Simple Guide to Water Heater Maintenance

A water heater ensures that a household runs well. When the water cools or depletes you will notice, which can be quite unpleasant if you were looking to take a hot shower. To ensure that this never happens, here are a few small steps that you can do to maximize the potential of your water heater, without having to take it apart.

Flush It

Aged gas water heater will advantage most from frequent flushings. Doing so will eliminate sediment from the boiler, help to conserve energy, and permit the heater to uphold a warmer water temperature.

Insulate It

It can drop a tremendous amount of temperature and energy during the pipes also sides of the boiler. To stop this from happening, you can pad the pipes responsible for hauling the heated water around the house, which can be found in unheated crawlspaces. Plumbing pipe padding can be purchased at any hardware stores or even ordered online. Use padding tape to keep it in place.
Next, adding the hot water boiler. You can slash strips of fiberglass padding and join them to the sides of the heater. An alternate solution would be to apply a water heater blanket. These tightly cover your water heater to help insulate, and are outstanding at preventing heat loss.

Replace the Anode Rod

Corrosion is a major factor which can destroy your water heater. Water heaters have a average life span of 8 to 12 years, but you can boost the life of your water heater by replacing the anode bar. An anode bar will oxidize before the steel does, which works by serving as a sacrificial corrosion attractant. Once the anode bar rusts, your boiler is next. Replacing an anode bar which will add years to your water heater.

Beyond Repair

When a boiler begins to leak, it’s finished, and there’s nothing that can be done about it. Make sure that you do regular maintenance on your water heater to maximize its lifespan.

Leave a Reply

Your email address will not be published. Required fields are marked *